Dynamix UM-S User Manual download pdf (Page 64)

Dynamix UM-SE G.SHDSL.bis EFM Bridge Modem User Manual V003 63

4 Configuration use Serial Console and Telnet with Menu

Driven Interface

4.1 Introduction

4.1.1 Login to the Console Interface

The console port is a RJ-48C connector that enables a connection to a PC for monitoring and

configuring the EFM modem. Use the supplied serial cable with a female DB-9 connector to

serial port of PC and RJ-48C module jack connector to EFM modem’s console port. Start your

terminal access program by terminal emulation program or Hyper Terminal and configure its

communication parameters to match the following default characteristics of the console port:

Parameter Value

Baud rate 9600

Data Bits 8

Parity Check None

Stop Bits 1

Flow-control None

After finished the parameter settings, press the SPACE key until the login screen appears.

When you see the login screen, you can logon to this EFM Modem.

Note: Only SPACE key invoke the login prompt. Pressing other keys does not work.

The system asks for User and Password, please enter “admin” both for the factory default

password. As show in the following:

User: admin

Password: *****

4.1.2 Telnet login

The EFM modem also supports telnet for remote management.

Make sure the correct Ethernet cable connected the MGMT port of EFM modem to your

computer. The MGMT indicator on the front panel shall light if a correct cable is used. Starting

your Telnet client with VT100 terminal emulation and connecting to the management IP of EFM

modem, wait for the login prompt appears. Input User and Password after login screen pop up.

The system asks for User and Password, please enter “admin” both for the factory default

password. As show in the following:

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 104 105

No comments

Dynamix UM-S User Manual Page 64