Dynamix DW - 01/S User Manual download pdf (Page 8)

1000 - 2000 VA

User’s Manual

1019297

Revision A

2 Installation

Inspecting the Equipment

If any equipment has been damaged during shipment, keep the shipping cartons and

packing materials for the carrier or place of purchase and file a claim for shipping

damage. If you discover damage after acceptance, file a claim for concealed damage.

To file a claim for shipping damage or concealed damage: 1) File with the carrier within

15 days of receipt of the equipment; 2) Send a copy of the damage claim within 15 days

to your service representative.

Installing the UPS

The following steps explain how to install the UPS. See “UPS Rear Panels” on page 9 for

the rear panel of each model.

NOTE Do not make unauthorized changes to the UPS; otherwise, damage may occur

to your equipment and void your warranty.

1. If installing an optional EBM, continue to Step 2; otherwise, skip to Step 4.

2. Plug the EBM cable into the battery connector on the UPS rear panel.

3. If a second EBM is to be installed, plug the EBM cable of the second cabinet into

the battery connector on the first EBM. Up to four EBMs may be connected to the

UPS.

4. If you are installing power management software, connect your computer to the

UPS communication port using the supplied communication cable.

5. Plug the detachable UPS power cord, into the input connector on the UPS rear

panel.

6. Plug the UPS power cord into a power outlet. The front panel indicators cycle

through a startup sequence while the UPS conducts a self–test.

When the self-test is complete, the indicator flashes, indicating the UPS is in

Standby mode with the equipment offline. If the alarm beeps or a UPS alarm

indicator stays on, see Table 2 on page 22.

7. Plug the equipment to be protected into the appropriate UPS output receptacles

(see page 15 for more information on load segments).

DO NOT protect laser printers with the UPS because of the exceptionally high

power requirements of the heating elements.

8. Press and hold the On button until you hear the UPS beep (approximately one

second). The indicator stops flashing and the bar graph indicators display the

percentage of load being applied to the UPS.

The UPS is now in Normal mode and supplying power to your equipment.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 23 24

No comments

Dynamix DW - 01/S User Manual Page 8